answer 1
estimate to be about a foot ,without going out in the cold and measuring it ,,hole is for standard size pin used for this purpose on most all hitches, i did shorten my rack tounge about 6 inches and drilled a new hole to mount rack closer to the vehicle ,,but would not have been necessary, adapter was fine as it came .did nothing to it .
answered 1 year, 6 months ago
by
BJon
- rural south central Oregon
-1point
0out of 1found this answer helpful.
answer 2
The hole is 5/8 inch. The overall length of the adapter is 7 inches.
+1point
1out of 1found this answer helpful.
answer 3
One hole is 5/8" in diameter (located 2.5" from the end of the adapter that slides into the 2" receiver). The other hole is 1/2" in diameter (located 1.5" from the end of the adapter that accepts the 1" ball mount, bike rack, etc.).
The adapter is 7" long.
answered 1 year, 6 months ago
by
370pursang
- Raleigh, NC
+3points
3out of 3found this answer helpful.