Does this clutch use a .250 inch keyway, and is it on both the driven and the driver bores?
This is very important in that I'm driving two shafts that are in alignment with each other. Also, if I chose to purchase a Hilliard clutch for a gear rather than a pulley do you sell do you sell the coresponding gear for the driven shaft with a 1 inch bore?
asked 4 years, 11 months ago
on "Hilliard Extreme-Duty Clutch - 1in. Bore, 3.0in. Pulley O.D., For 1/2in.W 'A' Belts and 5/8in.W 'B' Belts"
0out of 0found this question helpful.