Question
Does the battery need to be disconnected during desulphation?
I understand that the desulphation phase for the 12248 applies short duration, high voltage pulses to the battery. I'm concerned that if it remains connected to an automobile's electronics that they could be damaged - ECM, alarm, radio stand-by, remote entry electronics, etc.
Is it safe to connect it to the auto battery while it is in the vehicle and connected?
Are there any equipment damage warranties?
asked 1 year, 8 months ago
on BatteryMINDer Battery Charger / Maintainer with Desulphator - 12 Volt 2/4/8 Amp, Model# 12248
0points
0out of 0found this question helpful.
answer 1
The Battery Minder does not need to be disconnected during desulphation. The unit needs to be plugged into a 110 volt power source at all times during operation. The unit will not damage any of the automobile's electronics. The unit will perform as intended as long as the battery is in good working order. There are not equipment damage warranties available for this item.
answered 1 year, 8 months ago
+1point
1out of 1found this answer helpful.
answer 2
It is perfectly safe to connect to your battery while in the vehicle. We do not have an equipment damage warranty (we have a 5 year manufactures warranty), but we have never had any issues.
Car alternators put out much higher voltages and dirtier power then a BatteryMINDer. As such the equipment in your car is built with much higher voltage tolerances then a BatteryMINDer will ever put out.
answered 1 year, 7 months ago
by
Anonymous
- Huntington NY
+1point
1out of 1found this answer helpful.
answer 3
Yes. I have used this product for over five years and it works just as well right in the vehicle while the battery is hooked up to the vehicle. Make sure you disconnect it before starting as a precaution.
answered 1 year, 2 months ago
by
Louonthekey
- Siesta Key, Florida
+1point
1out of 1found this answer helpful.